You are here:Home > Roofing > Cedar Roof
R-Vent

R-Vent®

Advanced
0 Reviews
$184.95
Product Code: RVENT-S

Description

R-Vent® is a 40% recycled ventilation mat used in cedar, metal, & tile roof construction. The 90% open mesh creates an airspace/cavity that is perfect for promoting air flow in all directions between the metal panels and sheathing.

In sensitive cedar roofs, proper ventilation is vital. A high-performing ventilation mat product from Advanced Building Products, R-Vent is maximized to promote longevity in any cedar roof. R-Vent ventilation mats feature a 90% open mesh that creates a cavity that is perfect for promoting air flow in all directions between the metal panels and sheathing, allowing your roof to breathe. This increases your cedar roof's durability and longevity while reducing sound transmission and contributing to LEED points. Get a full list of the many benefits that come with using R-Vent® roof ventilation mat products below, and order yours at competitive prices online from our trusted supply team here at Spycor Building Products.


  • Creates an open structure for ventilation
  • Prolongs life of membrane and roof structure
  • Reduces sound transmission through panels
  • Lightweight and easy for installers to handle
  • Bends and conforms to any type of contoured roof
  • Contributes to LEED points
  • 9.16mm, 39" X 61.5' Roll

Technical Specs

Thickness: 0.361 in. (9.16 mm)
Roll Width: 39.0 in. (99.06 cm)
Roll Length: 61.5 ft. (18.75 m)
Coverage Area: 200 ft.2 (18.58 m2)
Rolls per Pallet: 120

Installation Instructions:
Install plywood roof sheathing onto rafters. Install roofing felt or ice dam protection membrane over sheathing. Check local codes and manufacturer’s recommendations for specific requirements.Install R-Vent® over roofing felt, ice protection membrane, and metal edge flashing or drip edge. Ensure R-Vent® material is installed flush against edge of the flashing or drip edge. Carefully trim the R-Vent® material at all penetrations with a utility knife or scissors.When installing metal or alternate material shingles, unroll R-Vent® horizontally just ahead of the shingles as they are installed. Tack or nail R-Vent® in place every three square feet. Do not overlap the R-Vent® material. Butt each course tightly against the previous course and at vertical seams.When installing vertical metal roofing panels, unroll R-Vent® vertically from ridge to eave just ahead of the metal panels as they are installed. Tack or nail R-Vent® in place every three square feet. Do not overlap the R-Vent® material. Butt each course tightly against the previous course and at vertical seams.At ridge locations, extend R-Vent® material over the ridge and butt against the material on the opposite side of the roof. If a ridge vent is utilized, follow the ridge vent manufacturer’s recommendations for underlayment material installation.Apply roofing materials using manufacturer’s recommended fasteners and instructions, allowing for the additional thickness of the R-Vent® material.

Reviews

Average Customer Review:
( 0 )